Intempo Gx 01 Internet Radio Instructions

I need help with choosing a new power supply for my internet radio which won’t interfere with and give feedback into the speakers.Current power is aDYS switching mode power supply Model dys18-090150w-3Output 9.0v - 1.5a13.5va maxThe current power supply has packed up and I can’t find the same model anywhere, I know power supplies are readily available, but I don’t want to buy one to find it gives a load of noise through the radioSo thought I might ask for a bit of advice before I part with the cash!!ThanksNick. It is unlikely that a modern switched mode power supply will cause problems with feedback or speakers.These PSU are made in large numbers in China. Various models are available from electronics suppliers i.e. Rapid, Maplin etc. Nito installer xbmc addons.

You do not need a specific Intempo model, all 9V DC is the same.You know the voltage 9V and the current rating 1.5A. It is important that the replacement PSU is rated at 1.5A or higher. The other important thing is the size of the plug and the polarity of the plug - is the centre of the plug positive or negative (this information may be on your existing Intempo PSU or shown in the manual).

The Intempo GX (affectionately called Galaxy at Intempo Towers) is Intempo’s first Internet Radio and is officially loved by the popular gadget magazine, T3 (November issue) The GX has been hailed as one of the easiest Internet Radios to use. When it is in range of a wireless connection then it will automatically detect.

All this means is that it intended to convert AC to 9V DC. It is also a universal PS able to cope with AC from 100-240Volts, either 50 or 60 Hz. The 0.45A is the maximun current it draws from the mains.

Common Maxxforce 13 EGR Delete Problems PROBLEM 1: Black Smoke Is Appearing from The Exhaust The primary job of the EGR is to help reduce nitrogen oxide emissions from the engine. This is done by allowing in the cooled exhaust gas into the air inlet duct to keep temperatures low enough so that nitrous oxide does not form in the first place. Maxxforce 13 engine egr delete.

In other words it is a universal PSU, which is very common form switch mode PSUs.The following 9V PSU from Rapid would be suitable, assuming that the plug is 2.1mm diameter (a very common size)If the plug is a different size they do alternative PSUs which have a selection of interchangeable plugs in different sizes.Hope this helps.